Iron Fitting
Most iron sets are gapped for distance and checked for lie angle, but rarely checked for whether every club in the set presents the same visual picture at address — and a topline that shifts subtly from a 5-iron to a pitching wedge asks your eyes to relearn the read on every single club.
Checking the Topline, Not Just the Lie Angle
We photograph your setup with every club in a candidate set from directly overhead, comparing topline width, offset, and blade length across the range. A set that gaps perfectly for distance can still ask your eyes to adjust to a noticeably different look every few clubs.
Where that inconsistency shows up, we test alternate models or partial-set combinations to keep the visual picture stable from wedge through long iron, rather than treating each club as an independent build.
The Build Decisions That Matter Most
Topline Width
Wider toplines on longer irons and thinner toplines on shorter ones can create a set that reads inconsistently at address even though every lie angle checks out.
Offset
Progressive offset changes how far forward the leading edge sits club to club, shifting your eye-line reference from one iron to the next.
Dynamic Lie Angle
Checked at impact using the actual sole pattern, since a static reading at address doesn't capture how the club sits once your hands are moving.
Build a Set That Reads the Same, Club to Club
Sessions run 60–90 minutes and compare topline consistency across every club in a candidate set.